DIGI*TRAC Guide:

DIGI&TRAC Design & Installation Guide (.pdf)

CCM Downloads:

To update your controllers to the most recent version of the Command & Control Module (CCM), you can order and install a new CCM board, or you can download the firmware from the Hirsch website and then use Velocity to upload the firmware to the CCM.  The upload/rewrite process is called “flashing” the CCM. 

In order to be flashable, the CCM’s BIOS version must be 7.1.20 or higher (how to check), and the sticker on the chip (U3) in the lower left hand corner of the CCM board must indicate version code 021118 or higher.  If your CCM does not meet these requirements, do not attempt to flash it through Velocity.  Instead, replace the CCM board. 

Please consult the Velocity Release Notes and Velocity Administrator’s Guide for the specific Velocity version you are using before choosing which CCM version to download and before flashing the CCM.  These documents can be found within the Velocity software’s Help system or by navigating from the main Downloads & Documents page.

Additional:

Flashmaster User’s Guide (.pdf)

DIGI*TRAC Annunciator Guide (.pdf)